Pre-Work Checklist D185T4F

The following items should be checked as indicated to maintain the warranty and ensure years of trouble-free service from the machine.

DAILY:

  • Engine oil level 
    • Oil must reach the full mark, located on the fifth line up from the end of the dipstick.
  • Engine coolant level
    • Top off with Green 50/50 Coolant mix.  Fill reservoir completely.
  • Compressor oil level
    • Oil must reach the full mark which is located where “MAX” is on the dipstick.
  • Check for leaks in fuel lines, fuel filter seal, and fuel tank cap
  • Check for leaks in oil filter seal, hydraulic lines and fittings, pneumatic blue lines, and clear lines
  • Make sure there is no obstruction of the canopy vents. 
    • Obstruction could include debris in the vents or proximity of the vents to a vehicle or structure.
  • Make sure there is no obstruction in the radiator fins.
    • Obstruction could include blast media or debris preventing air flow through the radiator.
  • Check engine air filters (in severe conditions)
    • To remove debris, tap out filter media with the large filter opening facing upward on a hard surface.  Replace filter element if necessary.
  • Check compressor air filters (in severe conditions)
    • To remove debris, tap out filter media with the large filter opening facing upward on a hard surface.  Replace filter element if necessary.

WEEKLY:

  • Engine air filter
    • Replace filter element if filter element is compromised or cannot be tapped out.
  • Compressor air filter
    • Replace filter element if filter element is compromised or cannot be tapped out.

MONTHLY:

  • Inspect battery electrolyte/water level, top off just above the cell plates.
    • Top off with Distilled water only

Any leaks found (Oil or Fuel) must be repaired before operation.

 

Download This Checklist

D185T4F Pre-Work Checklist Preview Cover Tilted